FW 08.01.00 McDATA E/OS Command Line Interface User Manual (620-000134-740, November 2005)

2
2-156
E/OS Command Line Interface User Manual
perf
Command Example Root> perf thresholdAlerts deleteAlert checklinks
perf.thresholdAlerts.setState
Syntax setState name enabledState
Purpose This command enables or disables specified threshold alert.
Parameters This command has the following parameters:
Command Example
Root> perf thresholdAlerts setState checklinks enabled
perf.thresholdAlerts.show
Syntax show
Purpose This command displays information about all threshold alerts.
Parameters This command has no parameters.
Command Example
Root> perf thresholdAlerts show
Output The data is displayed as a table that includes the following
properties:
name The name of a threshold alert as defined by
the commands
perf.thresholdAlerts.counter.addAlert and
perf.thresholdAlerts.throughput.addAlert.
enabledState Sets the counter threshold alert enabled state.
Valid values are enable and disable. Boolean 1
and 0 values may also be substituted.
Name The name of the threshold alert (truncated to 51
characters).
Type The trigger statistic or threshold type of the alert
(abbreviated to 17 chars).
Tx Util TTA - Transmit Utilization
Rx Util TTA - Receive Utilization