FW 08.01.00 McDATA E/OS Command Line Interface User Manual (620-000134-740, November 2005)

2
CLI Commands
2-155
perf
Command Example Root> perf threshAlerts counter showStatisticTable
Output Example The output from the perf.thresholdAlerts.counter.showStatisticTable
command appears as follows:
NumberCounter or Counter Set
----------------------------
1 Link Resets Sent
2 Link Resets Received
3 OLS Sent
4 OLS Received
5 Link Failures
6 Sync Losses
7 Signal Losses
8 Protocol Errors
9 Invalid Tx Words
10 CRC Errors
11 Discarded Frames
12 Frames Too Short
13 Delimiter Errors
14 Address ID Errors
15 Cls2 BusiedFrms
16 Cls2 RejectedFrms
17 Cls3 DiscardFrms
18 Phys Lnk Err Set
19 Lnk Seq Cnt Set
20 Logic Lnk Err Set
21 LIPS Detected
22 LIPS Generated
perf.thresholdAlerts.deleteAlert
Syntax deleteAlert name
Purpose This command deletes a specified threshold alert.
NOTE: An alert cannot be modified unless it is in the disabled state. Verify
that the alert is disabled before executing this command.
Parameters This command has one parameter:
name The name of a threshold alert as defined by the
commands perf.thresholdAlerts.counter.addAlert
and perf.thresholdAlerts.throughput.addAlert, or,
enter all to delete all of the configured
threshold alerts.