FW 08.01.00 McDATA E/OS Command Line Interface User Manual (620-000134-740, November 2005)

2
2-152
E/OS Command Line Interface User Manual
perf
with the threshold alert name created using the
perf.thresholdAlerts.counter.addAlert command.
NOTE: An alert cannot be modified unless it is in the disabled state. Verify
that the alert is disabled before executing this command.
Parameters This command has the following parameters:
Command Example
Root> perf thresholdAlerts counter setCounter checklinks 1
name The name of a counter threshold alert as
defined by the command
perf.thresholdAlerts.counter.addAlert, described
in 2-149.
counterNumber Specifies the counter number. Valid values are
shown in Table 2-3, Alert Counters, page 2-147.