FW 08.01.00 McDATA E/OS Command Line Interface User Manual (620-000134-740, November 2005)

2
2-150
E/OS Command Line Interface User Manual
perf
perf.thresholdAlerts.counter.addPort
Syntax addPort name portNumber
Purpose This command adds a port to the specified counter threshold alert.
NOTE: An alert cannot be modified unless it is in the disabled state. Verify
that the alert is disabled before executing this command.
Parameters This command has the following parameters:
Specifying a port type removes all the ports from the alert and
applies the alert to each port that is the specified type of port. Valid
values are:
•eport
•fport
• flport (Sphereon 4300 and Sphereon 4500 only)
NOTE: A counter threshold alert is not allowed to specify both port types
and individual port numbers.
name The name of a counter threshold alert as
defined by the command
perf.thresholdAlerts.counter.addAlert on
page 2-149.
portNumber Specifies the port number or port type. Valid
port number values:
0–11 for the Sphereon 4300
0–15 for the Sphereon 3016 and 3216
0-15 for the Sphereon 4400
0–23 for the Sphereon 45000–31 for the
Sphereon 3032 and 3232
0-31 for the Sphereon 4700
0–63 for the Intrepid 6064
0–127 and 132–143 for the Intrepid 6140
all applies the counter threshold alert to every
port on the product.