FW 08.01.00 McDATA E/OS Command Line Interface User Manual (620-000134-740, November 2005)

2
2-146
E/OS Command Line Interface User Manual
perf
• perf.thresholdAlerts.counter.setParams on page 2-153
• perf.thresholdAlerts.counter.show on page 2-154
• perf.thresholdAlerts.counter.showStatisticTable on page 2-154
4. Once the alert is fully configured, activate the alert using the
perf.thresholdAlerts.setState command described on 2-156. To
modify an alert you will need to disable it first.
Activating a Throughput Threshold Alert
In order to activate a throughput threshold alert using the CLI, you
must enter certain commands in the specified sequence:
1. Create a throughput threshold alert using the command
perf.thresholdAlerts.throughput.addAlert on page 2-158. Use this
command to create a name for the threshold alert that you can use
in subsequent commands. The threshold alert must then be
configured using the other throughput threshold alert
commands.
2. Assign the threshold alert to a port using the command
perf.thresholdAlerts.throughput.addPort on page 2-159.
3. Identify the throughput statistic that triggers the throughput
threshold alert using the command
perf.thresholdAlerts.throughput.setUtilType on page 2-161.
4. Identify the percentage of throughput that triggers the
throughput threshold alert using the command
perf.thresholdAlerts.throughput.setUtilPercentage on page 2-162.
5. Configure the threshold alert using other perf.thresholdalert
commands. For example, you may want to set the duration and
interval times for the alert, as described in
perf.thresholdAlerts.throughput.setParams on page 2-163. Use the
following commands to view alert settings and configure an alert:
• perf.thresholdAlerts.throughput.removePort on page 2-160
• perf.thresholdAlerts.throughput.setParams on page 2-163
• perf.thresholdAlerts.throughput.show on page 2-164
• perf.thresholdAlerts.throughput.showUtilTypeTable on page 2-164
6. Once the alert is fully configured, it can be activated using the
perf.thresholdAlerts.setState command, described on 2-156. You
will need to disable an alert before you can modify it.