FW 08.01.00 McDATA E/OS Command Line Interface User Manual (620-000134-740, November 2005)

2
2-144
E/OS Command Line Interface User Manual
perf
Command and
Output Examples
The following examples show the output returned by the three
methods of specifying the perf.preferredPath.showPath command.
Single values for both parameters
Root> perf preferredPath showPath 21 10
Preferred Path State: Enabled
Preferred Exit Port: Not Configured
destDomainId set to all
Root> perf preferredPath showPath all 15
Preferred Path State: Enabled
Destination Domain Preferred Exit Port
------------------ -------------------
1 23
3 24
4 23
17 12
sourcePort set to all
Root> perf preferredPath showPath 1 all
Preferred Path State: Enabled
Source Port Preferred Exit Port
------------------ -------------------
0 2
2 5
3 17
22 5
perf.preferredPath.showState
Syntax showState
Purpose This command shows the enabled state for preferred path
Parameters This command has no parameters.
Command Example
Root> Perf PreferredPath showState
perf.thresholdAlerts
The perf.thresholdAlerts commands enable you to configure alerts that
notify you of specific conditions on your system.