FW 08.01.00 McDATA E/OS Command Line Interface User Manual (620-000134-740, November 2005)

2
2-142
E/OS Command Line Interface User Manual
perf
perf.preferredPath.setState
Syntax setState enabledState
Purpose This command enables or disables the preferred path feature.
NOTE: Insistent domain IDs must be used in order to enable the preferred
path state.
Parameters This command has one parameter:
Command Example
Root> perf preferredPath setState enable
perf.preferredPath.showPath
Syntax showPath destDomainID sourcePort
Purpose This command displays the requested preferred path configuration.
The output shows the configured preferred exit port. Using all for
either the destination domain ID or the specified source port
parameter results in an output that shows all configured and actual
exit ports for the other parameter. If the destination domain is set to
all, then all paths from the specified source port are displayed. If the
source port is set to all, the output shows all source port paths to the
specified domain. You cannot specify all for both the parameters.
enabledState Sets the state of the preferred path
feature. When disabled, the preferred
path settings are ignored for all path
selection decisions. Accepted values for
this command are enable and disable.
Boolean 1 and 0 may be substituted as
values.