FW 08.01.00 McDATA E/OS Command Line Interface User Manual (620-000134-740, November 2005)

2
2-120
E/OS Command Line Interface User Manual
config
config.zoning.renameZone
Syntax renameZone oldZoneName newZoneName
Purpose This command renames a zone in the work area.
Parameters This command has two parameters:
Command Example
Root> config zoning renameZone TheOldUltimateZone
TheUltimateZone
config.zoning.renameZoneSet
Syntax renameZoneSet zoneSetName
Purpose This command changes the name of the zone set in the work area.
NOTE: Changes are not activated on the switch until the
config.zoning.activateZoneSet command is issued.
Parameters This command has one parameter:
oldZoneName Specifies the current zone name of the zone to
be renamed.
newZoneName Specifies the new zone name. The
newZoneName must contain 1–64 characters.
Valid characters are:
ABCDEFGHIJKLMNOPQRSTUVWXYZabcdef
ghijklmnopqrstuvwxyz0123456789$-^_
Spaces are not permitted, and the first character
must be alphabetical.
zoneSetName Specifies the new name for the zone set. The
zoneSetName must contain 1–64 characters.
Valid characters are:
ABCDEFGHIJKLMNOPQRSTUVWXYZabcdef
ghijklmnopqrstuvwxyz0123456789$-^_
Spaces are not permitted, and the first character
must be alphabetical.