FW 08.01.00 McDATA E/OS Command Line Interface User Manual (620-000134-740, November 2005)

2
CLI Commands
2-117
config
Command Example Root> config zoning addZone TheUltimateZone
config.zoning.clearZone
Syntax clearZone zoneName
Purpose This command clears all zone members for the specified zone in the
work area. This command does not change the zone name.
Parameters This command has one parameter:
Command Example
Root> config zoning clearZone TheNotUltimateAtAllZone
config.zoning.clearZoneSet
Syntax clearZoneSet
Purpose This command clears the zone set contained in the work area,
removing all zones, and takes effect immediately. This command
does not change the zone set name.
Parameters This command has no parameters.
Command Example
Root> config zoning clearZoneSet
config.zoning.deactivateZoneSet
Syntax deactivateZoneSet
Purpose This command places all attached devices in the default zone and
takes effect immediately for the entire fabric. This command clears
both the active zone set and the working area. This command takes
effect immediately in the fabric.
NOTE: The default zone must be activated independently of this command.
Parameters This command has no parameters.
Command Example
Root> config zoning deactiveZoneSet
zoneName Specifies the name of the zone to be cleared.