FW 08.01.00 McDATA E/OS Command Line Interface User Manual (620-000134-740, November 2005)

2
CLI Commands
2-115
config
Purpose This command adds the domain ID and port number of a zone
member to the specified zone in the work area.
NOTE: Port numbers cannot be used for zone members if the interoperability
mode for the switch or director is set to Open Fabric 1.0 mode.
NOTE: A product can have a maximum of 4096 zone members in its zones.
NOTE: The ED-5000 supports a maximum of 512 zones.
Parameters This command has the following parameters:
Command Example
Root> config zoning addPortMem TheUltimateZone 10 6
config.zoning.addWwnMem
Syntax addWwnMem zoneName wwn
Purpose This command adds a WWN zone member to the specified zone in
the work area.
NOTE: A product can have at most 4096 zone members in its zones.
zoneName Specifies the name of the zone.
domainId Specifies the domain ID of the member to be
added to the zone. Valid values are in the range
1–31.
portNumber Specifies the port number of the member to be
added to the zone. Valid port number values
are:
0–11 for the Sphereon 4300
0–15 for the Sphereon 3016 and 3216
0–23 for the Sphereon 4500
0–31 for the Sphereon 3032 and 3232
0–31 for the ED-5000
0–63 for the Intrepid 6064
0–127 and 132–143 for the Intrepid 6140