FW 08.01.00 McDATA E/OS Command Line Interface User Manual (620-000134-740, November 2005)

2
2-114
E/OS Command Line Interface User Manual
config
Fabrics Configuration Document located on www.mcdata.com in the
Resource Library or contact your customer support representative.
config.zoning.activateZoneSet
Syntax activateZoneSet
Purpose This command activates the zone set contained in the work area to
the fabric and takes effect immediately.
NOTE: This command takes effect immediately in the fabric.
Parameters This command has no parameters.
Command Example
Root> config zoning activateZoneSet
NOTE: If the interoperability mode for the switch or director is set to Open
Fabric 1.0 mode when the zone is activated, any zone members specified by
the port number are ignored.
config.zoning.addPortMem
Syntax addPortMem “zoneName” domainId portNumber
Table 2-1 Supported Zoning Configurations
Product
Intrepid 6064
Intrepid 6140
Sphereon
4700
Sphereon
4400
Sphereon
4500
Sphereon
4300
Sphereon
3x32
Sphereon
3x16
ED-5000
Number of End
Ports
1024 1024 1024 1024 1024 1024 1024
Unique Zone
Members
4096 4096 4096 4096 4096 4096 1042
Members per
Zone
4096 4096 4096 4096 4096 4096 1024
Zones 2048 2048 2048 2048 2048 2048 512