FW 08.01.00 McDATA E/OS Command Line Interface User Manual (620-000134-740, November 2005)

CLI Commands

2-109

config

config.syslog.show

Syntax show

Purpose This command displays the syslog configuration.

NOTE: The command show.syslog on page 2-234 has functionality that is the

same as this command.

Parameters This command has no parameters.

Output The syslog configuration is shown as a table of properties. The

following properties are displayed:

Command Example

Root>Config SysLog show

Syslog State: Disabled

Index IP Address Facility

----- --------------- --------

1 172.16.22.23 Local 0

3 180.77.66.55 Local 5

Log State

-------------------------- --------

Event Log Enabled

Open Trunking Re-Route Log Disabled

Link Incident Log Disabled

Security Log Enabled

Audit Log Enabled

Fabric Log Enabled

Embedded Port Frame Log Disabled

Log The index number of the server.

State Reports if syslog support is enabled.

Index The index number of the server.

IP Address The IP address of the server.

Facility The facility level for the server. Values are

Local 0 - Local 7.