FW 08.01.00 McDATA E/OS Command Line Interface User Manual (620-000134-740, November 2005)

2
CLI Commands
2-103
config
config.switch.safeZoning
Syntax safeZoning safeZoningState
Purpose This command sets the state for safe zoning. When enabled, zone
merges will not happen unless zone sets are equivalent; in addition,
the option to set the default zone will be disabled.
Parameters This command has one parameter:
Command Example
Root> config switch safeZoning enable
config.switch.speed
Syntax speed switchSpeed
Purpose This command sets the speed for the switch.
NOTE: This command is only applicable for the Intrepid 6064.
NOTE: The switch must be set offline before this command is entered.
A switch can be configured to operate at 1 Gbps or 2 Gbps.
If the switch has FPM cards, configuring the switch speed to 2 Gbps
makes all the ports on the FPM cards inactive, and their operational
state will be set to inactive. FPM ports do not support 2 Gbps and,
therefore, will remain inactive after the switch is returned to the
online state.
Parameters This command has one required parameter.
Command Examples
Root> config switch speed 2g
safeZoningState This parameter can be set to enable or disable.
Boolean 1 and 0 values may also be
substituted.
switchSpeed Specifies the speed of the switch. Valid values
are 1 Gb/s or 2 Gb/sec.