FW 08.01.00 McDATA E/OS Command Line Interface User Manual (620-000134-740, November 2005)

2
2-100
E/OS Command Line Interface User Manual
config
Purpose This command sets the preferred domain ID for the switch or
director. The switch or director must be offline to complete this
command.
Parameters This command has one parameter:
Command Example
Root> config switch prefDomainId 1
config.switch.priority
Syntax priority Priority
Purpose This command sets the switch priority.
NOTE: The switch must be set offline before this command is entered.
Parameters This command has one parameter:
domainId Specifies the new preferred domain ID value.
This parameter must be an integer in the range
1–31.
Priority Specifies the switch priority. Valid values are:
principal, default, or neverprincipal.
principal — sets the numerical switch priority
to 1. The switch with a priority of 1 becomes the
principal switch; however, if two or more
switches have a priority of 1, the switch with
the lowest WWN becomes the principal switch.
default — sets the numerical switch priority to
254. If no switch is set to principal, the switch
with a priority 254 becomes the principal
switch; however, if two or more switches have a
priority of 254, the switch with the lowest
WWN becomes the principal switch.
neverprincipal — sets the numerical switch
priority to 255. This disables the switch from
becoming a principal switch.
At least one switch in a multiswitch fabric must
have a switch priority value of principal or
default.
The number codes 2–253 are not in use now.