FW 08.01.00 McDATA E/OS Command Line Interface User Manual (620-000134-740, November 2005)

2
CLI Commands
2-99
config
Parameters This command has one parameter:
TIP: It is recommended that all the switches in the fabric to be configured have the
same value for the ISL FSPF Cost Configuration parameter.
Command Example Root> config switch islFSPFCost equal
config.switch.ltdFabRSCN
Syntax ltdFabRSCN ltdFabRSCNState
Purpose This command sets the status of limited fabric RSCNs. When enabled,
fabric registered state change notifications (RSCNs) are suppressed
during an IPL.
Parameters This command has one parameter:
Command Example
Root> config switch ltdFabRSCN 1
config.switch.prefDomainId
Syntax prefDomainId domainId
islFSPFCostState This parameter can be set to equal or default.
If set to default, the value of the FSPF cost for
each port depends on the speed of the port. In
this case, the cost is inversely proportional to
the bit rate of the ISL. The higher the bit rate,
the lower the cost.
If set to enabled, every ISL on the switch has
the same FSPF cost, and considers only the
number of hops to determine the shortest
path, ignoring the speed of the port.
Select enabled if you want parallel ISLs of
different speeds to be considered equally.
ltdFabRSCNState Specifies whether the limited fabric RSCN state
is enabled. Valid values are enable and disable.
Boolean 1 and 0 may be substituted as values.