FW 08.01.00 McDATA E/OS Command Line Interface User Manual (620-000134-740, November 2005)

2
2-98
E/OS Command Line Interface User Manual
config
NOTE: The Insistent Domain ID must be enabled if the Enterprise Fabric
Mode (an optional SANtegrity feature) or Preferred Path is enabled.
config.switch.interopMode
Syntax interopMode interopMode
Purpose This command sets the interoperability mode for the switch. The
switch must be offline to complete this command.
NOTE: The switch must be set offline before this command is entered.
Parameters This command has one parameter:
Command Example
Root> config switch interopMode open
config.switch.islFSPFCost
Syntax islFSPFCost islFSPFCostState
Purpose This command configures the Fabric Shortest Path First (FSPF) cost of
Inter-Switch Links (ISLs) on the switch. Cost is used to determine the
shortest path (or the path which would take the least amount of time
for traffic to travel) to a destination.
interopMode Specifies the interoperability mode. Valid
values are mcdata and open:
mcdata — McDATA Fabric 1.0. Select this mode
if the fabric contains only McDATA switches
and directors that are also operating in
McDATA Fabric 1.0 mode.
open — Open Fabric 1.0. Select this mode if the
fabric contains McDATA switches and directors
and other Open Fabric-compliant switches.
Select this mode for managing heterogeneous
fabrics.