FW 08.01.00 McDATA E/OS Command Line Interface User Manual (620-000134-740, November 2005)

2
CLI Commands
2-97
config
Parameters This command has one parameter:
Command Example
Root> config switch edTOV 4
config.switch.haMode
Syntax haMode haEnabledState
Purpose This command sets the state of high availability.
Parameters This command has one parameter:
Command Example
Root> config switch haMode enable
NOTE: This command is applicable only to Sphereon 4400.
config.switch.insistDomainId
Syntax insistDomainId insistentDomainIdState
Purpose This command sets the insistent domain ID state for the switch.
Parameters This command has one parameter:
Command Example
Root> config switch insistDomainId 1
timeoutValue Specifies the new E_D_TOV value. The units for
this value are tenths of a second. This parameter
must be an integer in the range 2–600
(0.2 second to 60 seconds), and it must be
smaller than the R_A_TOV.
haEnabledState This parameter can be set to enable or disable.
Boolean 1 and 0 values may also be
substituted.
insistentDomainIdStat
e
Specifies whether the insistent domain ID
state is enabled. Valid values are enable
and disable. Boolean 1 and 0 may be
substituted as values.