FW 08.01.00 McDATA E/OS Command Line Interface User Manual (620-000134-740, November 2005)

2
2-96
E/OS Command Line Interface User Manual
config
Command Example Root> config switch apiState enable
config.switch.domainRSCN
Syntax domainRSCN domainRSCNState
Purpose Sets the domain RSCN state for the switch or director. You can run
this command when the switch or director is either offline or online.
When this parameter is enabled, domain registered state change
notifications (domain RSCNs) are sent between end devices in a
fabric to provide additional connection information to host bus
adapters (HBA) and storage devices.
As an example, this information might be that a logical path has been
broken because of a physical event, such as a fiber optic cable being
disconnected from a port.
Parameters This command has one parameter:
Command Example
Root> config switch domainRSCN 1
config.switch.edTOV
Syntax edTOV timeoutValue
Purpose Sets the error detect timeout value (E_D_TOV) for the switch.
NOTE: The switch must be set offline before this command is entered.
Special care should be used when scripting this command due to its
relationship with R_A_TOV.
domainRSCNState Specifies whether the domain RSCN state is
enabled. Valid values are enable and disable.
Boolean 1 and 0 may be substituted as values.