FW 08.01.00 McDATA E/OS Command Line Interface User Manual (620-000134-740, November 2005)

2
2-92
E/OS Command Line Interface User Manual
config
Output This command displays the following switch configuration data:
Command Example
Config.SNMP> showUserTable
SNMPv3 State: Enabled
Index Username Auth Protocol Privacy Protocol
----- -------------------------------- ----------------- ----------------
1 User1 No Authentication No Privacy
2 User2 HMAC-MD5 No Privacy
3 User3 HMAC-SHA DES
4
5
6
NOTE: This command and the command show.snmp.userTable on page 22-225
has the same functionality.
config.snmp.showV3GroupTable
Syntax showV3GroupTable
Purpose This command displays the Security-to-Group table.
Parameters This command has no parameters.
Output This command displays the following switch configuration data:
SNMPv3 State Indicates whether SNMPv3 is enabled or
disabled.
Index The index number.
Username The username.
Auth Protocol The Authentication Protocol.
Privacy Protocol The Privacy Protocol.
SNMPv3 State Indicates whether SNMPv3 is enabled or
disabled.
Index The index number.