FW 08.01.00 McDATA E/OS Command Line Interface User Manual (620-000134-740, November 2005)

2
2-88
E/OS Command Line Interface User Manual
config
config.snmp.show
Syntax show
Purpose This command shows the SNMP configuration of the switch.
Parameters This command has no parameters.
Command Example
Root> config snmp show
Output The switch configuration data is displayed as a table that includes the
following properties:
Output Example The output from the config.snmp.show command appears as follows:
SNMP Agent State: Enabled
FA MIB Version Number: 3.0
Authentication Traps: Enabled
Index Community Name WriteAuth Trap Recipient UDP Port
----- ----------------------------- --------- --------------- ------
SNMP Agent
State
The state of the SNMP agent. If it is disabled,
the SNMP agent does not respond to any
requests and does not produce any traps.
FA MIB Version
Number
Version of the Fibre Alliance MIB (FA MIB) that
the SNMP agent is configured to use.
Authentication
Traps
The state of the authentication traps (for
example, enabled) that are sent to SNMP
management stations when unauthorized
stations attempt to access SNMP information
from the switch.
Index The community index number.
Community
Name
The name of the community.
WriteAuth The write authorization state.
Trap Recipient The address of the trap recipient shown in
4-byte dotted-decimal format.
UDP Port The user datagram protocol (UDP) port number
to which the switch will send traps for each
recipient.