FW 07.00.00/HAFM SW 08.06.00 McDATA Sphereon 4300 Fabric Switch Installation and Service Manual (620-000171-010, April 2005)

2
2-50
McDATA Sphereon 4300 Fabric Switch Installation and Service Manual
Installation Tasks
Figure 2-30 Configure Panel (Zoning Page with Zone Set Tab)
2. To create a zone set that incorporates zones and zone members
(configured under Configure Zones on page 2-46), type a new zone
set name in the Zone Set Name field.
3. Click Save and Activate Zoning Configuration. After the zone set
name is validated, a confirmation dialog box displays.
4. Click OK to save and activate the new zone set. The message Your
changes to the Zoning configuration have been successfully
activated appears. Note the following:
• Rename pending zone set - To rename a zone set, type the
new name in the Zone Set Name field. Click Rename Pending
Zone Set. The new zone set name is validated and changed.
• Enable or disable default zone - To toggle (enable or disable)
the default zone state, click Enable Default Zone or Disable
Default Zone. Depending on the toggle state, the Default Zone
field changes to Enabled or Disabled.