FW 07.00.00/HAFM SW 08.06.00 McDATA Sphereon 4300 Fabric Switch Installation and Service Manual (620-000171-010, April 2005)

Installation Tasks

2-49

Installation Tasks

• Add member by attached node WWN - Select the WWN of an

attached device (node) from the Attached Node World Wide

Name drop-down list and click the adjacent Add Member

button. The device is added to the zone.

• Add member by WWN - Type the WWN of an attached

device in the World Wide Name field and click the adjacent Add

Member button. The device is added to the zone.

• Add member by domain ID and port number - Type the

domain ID (1 through 31) of the switch in the Domain ID field,

type the switch port number (0 through 11) to which a device

is attached, and click the adjacent Add Member button. The

device attached to that port is added to the zone.

7. Changes to a zone, zoning configuration, or zone member are not

saved and activated on the switch until saved as part of a zone

set. Go to Configure Zone Sets below to perform this function.

Configure Zone Sets

To configure zone sets at the SANpilot interface:

1. At the Configure panel and Zoning page, click the Zone Set tab. The

Zoning page displays with the Zone Set tab selected (Figure 2-30).