FW 07.00.00/HAFM SW 08.06.00 McDATA Sphereon 4300 Fabric Switch Installation and Service Manual (620-000171-010, April 2005)

2
2-44
McDATA Sphereon 4300 Fabric Switch Installation and Service Manual
Installation Tasks
— Subnet Mask (default is 255.0.0.0).
— Gateway Address (default is 0.0.0.0).
— Auto Negotiate.
— Speed.
— Duplex.
Only the IP Address, Subnet Mask, and Gateway Address fields are
configurable.
11. Change the IP address, subnet mask, and gateway address as
directed by the customer’s network administrator. To change the
switch network addresses, type the following at the C > prompt
and press the Enter key.
ipconfig xxx.xxx.xxx.xxx yyy.yyy.yyy.yyy zzz.zzz.zzz.zzz
The IP address is always xxx.xxx.xxx.xxx, the subnet mask is
always yyy.yyy.yyy.yyy, and the gateway address is always
zzz.zzz.zzz.zzz, where the octets xxx, yyy, and zzz are decimals
from zero through 255. If a network address is to remain
unchanged, type the current address in the respective field.
When the new network addresses are configured at the switch,
the message Request completed OK displays at the bottom of the
Sphereon 4300 - HyperTerminal window.
12. Select the Exit option from the File pull-down menu to close the
HyperTerminal application. A HyperTerminal message box
appears (Figure 2-26):
Figure 2-26 HyperTerminal Dialog Box (1)
13. Click Yes. A second HyperTerminal message box appears
(Figure 2-27):