FW 07.00.00/HAFM SW 08.06.00 McDATA Sphereon 4300 Fabric Switch Installation and Service Manual (620-000171-010, April 2005)

Installation Tasks

2-43

Installation Tasks

8. Configure the Port Settings parameters as follows:

— Bits per second - 115200.

— Data bits - 8.

— Parity - None.

— Stop bits - 1.

— Flow control - Hardware or None.

When the parameters are set, click OK. The Sphereon 4300 -

HyperTerminal window displays.

9. At the > prompt, type the user-level password (the default is

password) and press Enter. The password is case sensitive. The

Sphereon 4300 - HyperTerminal window (Figure 2-25 on page 2-43)

displays with software and hardware version information for the

switch, and a C > prompt at the bottom of the window.

Figure 2-25 Sphereon 4300 - HyperTerminal Window

10. At the C > prompt, type the ipconfig command and press the

Enter key. The Sphereon 4300 - HyperTerminal window displays

with configuration information listed as follows:

— MAC Address.

— IP Address (default is 10.1.1.10).