FW 07.00.00/HAFM SW 08.06.00 McDATA Sphereon 4300 Fabric Switch Installation and Service Manual (620-000171-010, April 2005)

2
2-30
McDATA Sphereon 4300 Fabric Switch Installation and Service Manual
Installation Tasks
Figure 2-17 Configure Panel (Security Page with Switch Binding Tab)
3. Click Submit. A confirmation dialog box appears. Click OK to
close the confirmation dialog box, activate the selected connection
policy, and change the switch binding state.
NOTE: The Disable Switch Binding selection cannot be activated while
Enterprise Fabric Mode is enabled and the switch is online.
4. The Attached Nodes drop-down list contains the world wide
names of attached Fibre Channel devices. To add a member (node
or device) to the switch binding membership list displayed at the
bottom of the page, perform one of the following:
• Select a WWN from the Attached Nodes drop-down list and
click the adjacent Add Member button.
• Type a new WWN in the Detached Node (WWN) field and click
the adjacent Add Member button.
5. To delete a device from the switch binding membership list, click
the Delete button adjacent to the device WWN. A confirmation
dialog box appears. Click OK to close the dialog box and delete
the device.