FW 07.00.00/HAFM SW 08.06.00 McDATA Sphereon 4300 Fabric Switch Installation and Service Manual (620-000171-010, April 2005)

2
Installation Tasks
2-25
Installation Tasks
Figure 2-14 Configure Panel (Management Page with OSMS Tab)
2. Select eithe Enable or Disable from the drop-down box:
• Select Enable to activate the OSMS. The message Your changes
to the host control enable state have been successfully
activated appears.
•Select Disable to deactivate the OSMS. The message Your
changes to the host control enable state have been
successfully activated appears.
3. To change the host control state, select enable or disable from the
drop-down box. Before you can enable host control state, OSMS
must be enabled.
Change User
Password
Perform this procedure to change the administrator-level and
operator-level passwords used to access the SANpilot interface
through the Enter Network Password dialog box.
1. At the Configure panel, click the Security tab. The Security page
displays with the Authorize Users tab selected (Figure 2-15).