FW 07.00.00/HAFM SW 08.06.00 McDATA Sphereon 4300 Fabric Switch Installation and Service Manual (620-000171-010, April 2005)

2
2-22
McDATA Sphereon 4300 Fabric Switch Installation and Service Manual
Installation Tasks
Figure 2-12 Configure Panel (Management Page with SNMP Tab)
a. Click the Enable SNMP Agent check box to enable or disable
the installed SNMP agent.
b. Select the Fibre Alliance management information base (FA
MIB) from the FA MIB Version drop-down list. This should be
set to match the level of FA MIB used by the SNMP
management stations that access the product. Available
selections are:
• FA MIB Version 3.0.
• FA MIB Version 3.1.
c. Click the Enable Authentication Traps check box to enable or
disable transmission of SNMP trap messages to configured
recipients.
d. For each trap recipient to be configured, type a community
name of 32 alphanumeric characters or less in the Community
Name field. The community name is incorporated in SNMP
trap messages to ensure against unauthorized viewing or use.