FW 07.00.00/HAFM SW 08.06.00 McDATA Sphereon 4300 Fabric Switch Installation and Service Manual (620-000171-010, April 2005)

Installation Tasks

2-21

Installation Tasks

6. At the PC, launch the browser application (Netscape Navigator

Internet Explorer).

7. At the browser, enter the switch’s new IP address as the Internet

URL. The Enter Network Password dialog box displays.

8. Type the default user name and password.

NOTE: The default user name is Administrator and the default

password is password. The user name and password are case-sensitive.

9. Click OK. The SANpilot interface opens with the View panel open

and the Switch page displayed.

Configure SNMP

Perform this procedure to configure community names, write

authorizations, network addresses, and user datagram protocol

(UDP) port numbers for up to six SNMP trap message recipients. A

trap recipient is a management workstation that receives notification

(through SNMP) if a switch event occurs. To configure SNMP trap

recipients:

1. At the View panel, select the Configure option at the left side of the

panel. The Configure panel opens with the Ports page displayed.

2. At the Configure panel, click the Management tab. The Management

page displays with the SNMP tab selected (Figure 2-12).