FW 07.00.00/HAFM SW 08.06.00 McDATA Sphereon 4300 Fabric Switch Installation and Service Manual (620-000171-010, April 2005)

2
2-20
McDATA Sphereon 4300 Fabric Switch Installation and Service Manual
Installation Tasks
b. At the Subnet Mask field, type the new value as specified by
the customer’s network administrator (default is 255.0.0.0).
c. At the Gateway Address field, type the new value as specified
by the customer’s network administrator (default is 0.0.0.0).
3. Click Activate to save and activate the changes. The following
message box displays (Figure 2-11).
Figure 2-11 Network Information Message Box
4. Update the address resolution protocol (ARP) table for the
browser PC.
a. Select the Exit option from the File menu to close the SANpilot
interface and browser applications. The Windows desktop
displays.
b. At the Windows desktop, click Start at the left side of the task
bar. The Windows Workstation menu displays.
c. At the Windows Workstation menu, sequentially select the
Programs and Command Prompt options. A disk operating
system (DOS) window displays.
d. Delete the switch’s old IP address from the ARP table. At the
command (C:\) prompt, type arp -d xxx.xxx.xxx.xxx, where
xxx.xxx.xxx.xxx is the old IP address for the switch.
e. Click close (X) at the upper right corner of the DOS window to
close the window and return to the Windows desktop.
5. At the switch front panel, press and hold the IML/RESET button
for ten seconds. The switch performs a power-on reset (POR).