FW 07.00.00/HAFM SW 08.06.00 McDATA Sphereon 4300 Fabric Switch Installation and Service Manual (620-000171-010, April 2005)

2
2-14
McDATA Sphereon 4300 Fabric Switch Installation and Service Manual
Installation Tasks
Configure
Operating
Parameters
Perform this procedure to configure the switch’s preferred domain
ID, insistent domain ID, rerouting delay, and domain registered state
change notifications (RSCNs). The switch must be set offline to
configure the preferred domain ID. To configure parameters:
1. Set the switch offline as follows:
a. At the Configure panel, select the Operations option at the left
side of the panel. The Operations panel opens and the Switch
page displays with the Beacon tab selected
b. Click the Online State tab, then click Set Offline. The message
Your operations changes have been successfully activated
appears.
2. At the Operations panel, select the Configure option at the left side
of the panel. The Configure panel opens with the Ports page
displayed.
3. At the Configure panel, click the Switch tab, then click the
Parameters tab. The Switch page displays with the Parameters tab
selected (Figure 2-8).
Figure 2-8 Configure Panel (Switch Page with Parameters Tab)
a. At the Preferred Domain ID field, type a value between 1
through 31. The domain ID uniquely identifies each switch in
a fabric.