FW 07.00.00/HAFM SW 08.06.00 McDATA Sphereon 4300 Fabric Switch Installation and Service Manual (620-000171-010, April 2005)

2
Installation Tasks
2-11
Installation Tasks
1. At the View panel, select the Configure option at the left side of the
panel. The Configure panel opens with the Ports page displayed
(Figure 2-4). Select the BB Credits tab is selected. Use the vertical
scroll bar to display additional port information rows.
2. It is recommended you select the Default values. If not, you can
enter values in the RX BB Credit field.
3. Select Activate to save the changes.
4. Place the port back online.
Figure 2-5 Configure BB Credits
Configure Switch
Identification
Perform this procedure to configure the switch name, description,
location, and contact person. The Name, Location, and Contact
variables configured here correspond respectively to the SNMP
variables sysName, sysLocation, and sysContact. These variables are
used by SNMP management workstations when obtaining data from
managed switches. To configure the switch identification:
1. At the Configure panel, click the Switch tab. The Switch page
displays with the Identification tab selected (Figure 2-6 on
page 2-12).