FW 07.00.00/HAFM SW 08.06.00 McDATA Sphereon 4300 Fabric Switch Installation and Service Manual (620-000171-010, April 2005)

Event Code Tables
A-1
A
Event Code Tables
An event is an occurrence (state change, problem detection, or
problem correction) that requires user attention or that should be
reported to a system administrator or service representative. An
event usually indicates a switch operational state transition, but may
also indicate an impending state change (threshold violation). An
event may also provide information only, and not indicate an
operational state change. Events are reported as event codes.
This appendix lists all three-digit event codes and provides detailed
information about each code. Event codes are listed in numerical
order and in tabular format, and are grouped as follows:
• 000 through 199 - system events.
• 300 through 399 - fan events.
• 400 through 499 - control processor (CTP) card events.
• 500 through 599 - port events.
• 800 through 899 - thermal sensor events.
Events are recorded in the event log of the SANpilot interface or at a
simple network management protocol (SNMP) workstation. An event
may also illuminate the system error (ERR) light-emitting diode
(LED) at the switch front panel.