FW 07.00.00/HAFM SW 08.06.00 McDATA Sphereon 4300 Fabric Switch Installation and Service Manual (620-000171-010, April 2005)

FRU Removal and Replacement
5-5
7. Open the Switch tab at the View panel and:
a. Ensure no amber LEDs illuminate that indicate a port
failure.
b. Click the graphic representing the port with the
replacement transceiver to open the Port Properties tab.
Verify port and port technology information is correct.
c. If a problem is indicated, go to MAP 0000: Start MAP on
page 3-6 to isolate the problem.
8. Restore communication to the port with the replacement
transceiver as directed by the customer. Refer to Block or Unblock a
Port on page 4-26 for instructions. Inform the customer the port is
available.
9. To clear the system error (ERR) LED on the switch front bezel
from the web browser connected to the SANpilot interface:
a. Click the Switch tab at the Operations panel. The Operations
panel opens with the Switch page displayed.
b. Click the Sys Err Light tab. The Switch page displays with the
Sys Err Light tab selected. A System Error Light is ON
message displays on the page.
c. Click Clear Light.
10. If necessary, close and lock the equipment cabinet door.