FW 07.00.00/HAFM SW 08.06.00 McDATA Sphereon 4300 Fabric Switch Installation and Service Manual (620-000171-010, April 2005)

4-40
McDATA Sphereon 4300 Fabric Switch Installation and Service Manual
Figure 4-34
Firmware Upgrade Complete Message Box
9. Click here to login to the switch and start a new SANpilot session.
The Enter Network Password dialog box displays.
10. Type the default user name and password.
NOTE: The default user name is Administrator and the default
password is password. The user name and password are case-sensitive.
11. Click OK. The SANpilot interface opens with the View panel open
and the Switch page displayed.
Reset Configuration Data
The SANpilot interface provides the option to reset the configuration
file to factory default values. The switch must be set offline prior to
restoring the configuration file. Configuration data in the file include:
• Switch identification data.
• Port configuration data.
• Switch and fabric operating parameters.
• Simple network management protocol (SNMP) configuration
information.
• Zoning configuration information.
To reset switch data to the factory default settings from the SANpilot
interface:
NOTE: When switch configuration data is reset to factory default values, all
optional features are disabled.