FW 07.00.00/HAFM SW 08.06.00 McDATA Sphereon 4300 Fabric Switch Installation and Service Manual (620-000171-010, April 2005)

Repair Information
4-27
1. When the SANpilot interface opens, the View panel and Switch
page appear as the default. At the View panel, select the Configure
option at the left side of the panel. The Configure panel opens with
the Ports page displayed (Figure 4-19).
Figure 4-19 Configure Panel (Ports Page)
2. Click the check box for the selected port in the Blocked column to
block the port (default is unblocked). A check mark in the box
indicates the port is blocked.
3. Click Activate at the bottom of the page to save and activate the
blocked configuration. The message Your changes to the port
configuration have been successfully activated appears.