FW 07.00.00/HAFM SW 08.06.00 McDATA Sphereon 4300 Fabric Switch Installation and Service Manual (620-000171-010, April 2005)

Repair Information
4-7
Viewing the Audit
Log
Select Monitor on the navigation panel. Select the Logs tab; the Logs
tab view displays. Select the Audit Log link. The Audit Log displays in
text format, as shown in Figure 4-6. The log displays in a separate
browser window. Close the browser window to close the log.
The audit lot provides:
• Date/Time: The date and time of the log entry.
• Source: The source of Audit Log event.
• User ID: Identifier of the user that issued the command. The
identifier is usually an IP Address.
• Action: The type of Audit Log event.
Figure 4-6 Viewing the Audit Log
Clearing the Audit Log ATTENTION! Before clearing logs, make sure the logs are not needed for
troubleshooting. Once a log is cleared, the data cannot be retrieved.
To clear the Audit Log, select Monitor and select the Logs tab. Select
the Clear Log button, next to the Audit Log link. A message displays
stating that the operation has been performed successfully.