FW 07.00.00/HAFM SW 08.06.00 McDATA Sphereon 4300 Fabric Switch Installation and Service Manual (620-000171-010, April 2005)

4-2
McDATA Sphereon 4300 Fabric Switch Installation and Service Manual
Procedural Notes
The following procedural notes are referenced in applicable repair
procedures. The notes do not necessarily apply to all procedures in
the chapter.
1. Before performing a procedure, read the procedure carefully and
thoroughly to familiarize yourself with the information and
reduce the possibility of problems or customer down time.
2. When performing procedures described in this chapter, follow all
WARNING statements, and statements listed in the preface of
this manual.
3. After completing steps of a detailed procedure that is referenced
from another procedure, return to the initial (referencing)
procedure and continue to the next step of that procedure.
Obtain Log Information
The SANpilot interface provides access to the following logs that
contain information for maintenance personnel:
•Event Log.
• Open Trunking Re-Route Log.
• Link Incident Log.
• Security Log
•Audit Log
•Fabric Log
• Embedded Port Frame Log
To open a log, click the Logs tab at the Monitor panel. The Monitor
panel opens with the Logs page displayed (Figure 4-1 on page 4-3).
At the Logs page:
• Select (double-click) a log title to open and view the contents of
the associated log, or
• Select (double-click) the All Logs title to open and simultaneously
view the contents of all logs.
The Logs page provides a Clear Log button for each log. Click the
button to delete all entries for the associated log. The Logs page also