FW 07.00.00/HAFM SW 08.06.00 McDATA Sphereon 4300 Fabric Switch Installation and Service Manual (620-000171-010, April 2005)

3-66
McDATA Sphereon 4300 Fabric Switch Installation and Service Manual
24
A zone merge process failed during ISL initialization. The following list
explains the reason:
• Failure reason 01 - An invalid data length condition caused an
error in a zone merge frame.
• Failure reason 08 - An invalid zone set format caused an error
in a zone merge frame.
• Failure reason F0 - A retry limit reached condition caused an
error in a zone merge frame.
• Failure reason F1 - An invalid response length condition caused
an error in a zone merge frame.
• Failure reason F2 - An invalid response code caused an error in
a zone merge frame.
Disconnect the fiber-optic jumper cable from the E_Port reporting the
problem, then reconnect the cable to the same port.
Did disconnecting and reconnecting the cable solve the problem and
was the resulting zone merge process successful?
NO YES
↓ The merged zone appears operational. Exit MAP.
Perform the data collection procedure and return the diskette to
McDATA for analysis. Contact the next level of support. Exit MAP.
Table 3-13 Bytes 8 through 11 Failure Reasons and Actions
Bytes 8 - 11 Failure Reason Action
01 Invalid data length. Go to step 24.
08 Invalid zone set format. Go to step 24.
09 Invalid data. Go to step 25.
0A Cannot merge. Go to step 25.
F0 Retry limit reached. Go to step 24.
F1 Invalid response length. Go to step 24.
F2 Invalid response code. Go to step 24.