FW 07.00.00/HAFM SW 08.06.00 McDATA Sphereon 4300 Fabric Switch Installation and Service Manual (620-000171-010, April 2005)

Diagnostics
3-51
compatible for both switches. At the SANpilot interface for both
switches:
a. At the View panel, select Configure at the left side of the panel.
The Configure panel opens with the Ports page displayed.
b. Click the Security tab, then click the Switch Binding tab. The
Switch Binding page displays.
c. The Attached Nodes drop-down list contains the world wide
names of attached Fibre Channel devices. Ensure these switch
binding membership lists are compatible for both switches
— To add a member (node or device) to the switch binding
membership list displayed at the bottom of the page, select a
WWN from the Attached Nodes drop-down list and click the
adjacent Add Member button; or type a new WWN in the
Detached Node (WWN) field and click the adjacent Add
Member button.
— To delete a device from the switch binding membership list,
click the Delete button adjacent to the device WWN. A
confirmation dialog box appears. Click OK to close the
dialog box and delete the device.
d. Click Submit. A confirmation dialog box appears. Click OK to
close the confirmation dialog box, activate the selected
connection policy, and change the switch binding state.
Did updating the switch binding membership lists solve the problem?
NO YES
↓ The switch appears operational. Exit MAP.
Contact the next level of support. Exit MAP.
34
A port connection is not allowed because of a Computer Network
Technologies (CNT) wide area network (WAN) extension mode
mismatch. Based on switch-to-switch differences between the ELP
maximum frame sizes allowed, a connection was not allowed to a
switch set to CNT WAN extension mode.
Contact McDATA support personnel to obtain software maintenance
release 4.02.00 or higher. This release is required to correct the
problem and allow McDATA switches to communicate with CNT
UltraEdge WAN Gateways. Exit MAP.