FW 07.00.00/HAFM SW 08.06.00 McDATA Sphereon 4300 Fabric Switch Installation and Service Manual (620-000171-010, April 2005)

3-42
McDATA Sphereon 4300 Fabric Switch Installation and Service Manual
Figure 3-13
Link Incident Log
c. If a link incident occurred, the affected port number is listed with
one of the following messages.
Link interface incident - implicit incident.
Link interface incident - bit-error threshold exceeded.
Link failure - loss of signal or loss of synchronization.
Link failure - not-operational primitive sequence (NOS) received.
Link failure - primitive sequence timeout.
Link failure - invalid primitive sequence received for the
current link state.
Did one of the listed messages appear in the Link Incident Log?
YES NO
↓ The switch appears operational. Exit MAP.
17
A link incident message appeared in the Link Incident Log or an event
code 581, 582, 583, 584, 585, or 586 was observed at the console of
an OSI server attached to the switch reporting the problem.
Clear the Link Incident Log at the SANpilot interface:
a. At the View panel, select Monitor at the left side of the panel.
The Monitor panel opens with the Port List page displayed.
b. Click the Logs tab, then click the Clear Log button adjacent
to the Link Incident Log entry. An Are you sure you want to
clear the Link Incident Log? message box displays.