FW 07.00.00/HAFM SW 08.06.00 McDATA Sphereon 4300 Fabric Switch Installation and Service Manual (620-000171-010, April 2005)

Diagnostics
3-41
15
Port beaconing may be enabled.
a. Consult the customer and next level of support to determine the
reason port beaconing is enabled.
b. Disable port beaconing at the SANpilot interface:
1. At the View panel, select Operations at the left side of the
panel. The Operations panel opens with the Switch and
Beacon pages displayed.
2. Click the Port tab. The Operations panel opens with the Port
and Beacon pages displayed.
3. Click the check box (checked) in the Beaconing State column
and click Activate to remove the check mark and disable
beaconing. The message Your changes have been
successfully activated appears.
Was port beaconing enabled because port failure or degradation was
suspected?
YES NO
↓ The switch appears operational. Exit MAP.
Go to step 1.
16
A link incident may have occurred. Inspect the Link Incident Log at the
SANpilot interface
a. At the View panel, select Monitor at the left side of the panel.
The Monitor panel opens with the Port List page displayed.
b. Click the Logs tab, then click the Link Incident Log entry. The
Link Incident Log displays (Figure 3-13).