FW 07.00.00/HAFM SW 08.06.00 McDATA Sphereon 4300 Fabric Switch Installation and Service Manual (620-000171-010, April 2005)

3-38
McDATA Sphereon 4300 Fabric Switch Installation and Service Manual
9
Ensure the switch reporting the problem is connected to facility AC
power. Inspect the switch for indications of being powered on, such
as:
• At the front bezel, an illuminated PWR LED (green)
or ERR LED (amber).
• Illuminated LEDs adjacent to Fibre Channel ports.
• Audio emanations and airflow from cooling fans.
Does the switch appear powered on?
YES NO
↓ Analysis for an Ethernet link, AC power distribution, or CTP
failure is not described in this MAP. Go to MAP 0000: Start
MAP on page 3-6. If this is the second time at this step,
contact the next level of support. Exit MAP.
10
Inspect Fibre Channel port operational states at the SANpilot
interface.
a. At the View panel, click the Port Properties tab. The Port
Properties page displays with port 0 properties displayed.
b. Click the port number (0 through 11) for which a failure is
suspected to display properties for that port.
c. Inspect the Operational State field. Scroll down the View panel
as necessary.
d. Table 3- 8 lists port operational states and MAP steps that
describe fault isolation procedures.
Table 3-8 Port Operational States and Actions
Operational State Action
Online No action required. Exit MAP.
Port Failure Go to step 6.
Offline Go to step 11.
Not Operational Go to step 11.
Testing Internal or external loopback test in process. Exit MAP.