FW 07.00.00/HAFM SW 08.06.00 McDATA Sphereon 4300 Fabric Switch Installation and Service Manual (620-000171-010, April 2005)

3-34
McDATA Sphereon 4300 Fabric Switch Installation and Service Manual
• The switch-to-PC Internet link could not be established.
• AC power distribution in the switch failed, or AC power was
disconnected.
• The switch CTP card failed.
The SANpilot interface is not operational and fault isolation must be
performed at the switch. Go to step 4.
14
Inspect the power supply (includes fan modules) operational state at
the SANpilot interface.
a. At the View panel, click the FRU Properties tab. The View panel
(FRU Properties tab) displays.
b. Inspect the Status field for the power supply.
Does the Status field display a Failed message for the power supply?
NO YES
↓ A fan module or power supply failure is indicated. Replace
the switch. Exit MAP.
15
Inspect the CTP card operational state at the SANpilot interface.
a. At the View panel, click the FRU Properties tab. The View panel
(FRU Properties tab) displays.
b. Inspect the Status field for the CTP card.
Does the Status field display a Failed message for the CTP card?
NO YES
↓ A CTP card failure is indicated. Replace the switch.
Exit MAP.
Additional analysis is not described in this MAP. Go to MAP 0000:
Start MAP on page 3-6. If this is the second time at this step, contact
the next level of support. Exit MAP.