FW 07.00.00/HAFM SW 08.06.00 McDATA Sphereon 4300 Fabric Switch Installation and Service Manual (620-000171-010, April 2005)

3-22

McDATA Sphereon 4300 Fabric Switch Installation and Service Manual

Was an event code 400 or 411 observed at the SANpilot Event Log?

YES NO

↓ Analysis for the failure is not described in this MAP. Go to

MAP 0000: Start MAP on page 3-6. Exit MAP.

Tabl e 3-4 on page 3-22 lists event codes, brief explanations of the

codes, and the associated steps that describe fault isolation

procedures.

POST/IML diagnostics detected a FRU failure as indicated by event

code 400 with supplementary event data.

a. At the SANpilot Event Log, examine the first two bytes

(0 and 1) of event data associated with event code 400.

b. Byte 0 is a FRU code that indicates the failed FRU. Byte 1 is the

slot number of the failed FRU (00 for a nonredundant FRU).

Table 3-5 lists byte 0 FRU codes and associated steps that describe

fault isolation procedures.

Table 3-4 MAP 200 Event Codes

Event

Code

Explanation Action

400 Power-up diagnostic failure. Go to step 4.

411 Firmware fault. Go to step 8.

Table 3-5 MAP 200 Byte 0 FRU Codes

Byte 0 Failed FRU Action

02 CTP card. Go to step 5.

05 Fan module. Go to step 6.

06 Power supply. Go to step 7.