FW 07.00.00/HAFM SW 08.06.00 McDATA Sphereon 4300 Fabric Switch Installation and Service Manual (620-000171-010, April 2005)

Diagnostics
3-13
17
Inspect the Status fields for switch FRUs.
Does the State field display a Failed message for any of the FRUs?
YES NO
↓ The switch appears operational. Exit MAP.
A FRU failure is indicated. Continue to the next step to obtain event
codes. If no event codes are found, go to MAP 0400: FRU Failure
Analysis on page 3-30. Exit MAP.
18
Obtain event codes from the SANpilot Event Log.
NOTE: If multiple event codes are found, note all codes and associated
severity levels. Record the date, time, and listed sequence, and determine if
the codes are related to the reported problem. Begin fault isolation with the
most recent event code with the highest severity level. Other codes may
accompany this event code, or may indicate a normal indication after a
problem is recovered.
a. At the View panel, select Monitor at the left side of the panel.
The Monitor panel opens with the Port List page displayed.
b. Click the Logs tab. The Logs page displays (Figure 3-5).
Figure 3-5 Monitor Panel (Logs Page)