FW 07.00.00/HAFM SW 08.06.00 McDATA Sphereon 4300 Fabric Switch Installation and Service Manual (620-000171-010, April 2005)

Diagnostics

3-11

Does the Beaconing field display an On message?

YES NO

↓ Go to step 13.

Port beaconing is enabled.

a. Consult the customer and next level of support to determine the

reason port beaconing is enabled.

b. Disable port beaconing at the SANpilot interface:

1. At the View panel, select Operations at the left side of the

panel. The Operations panel opens with the Switch and

Beacon pages displayed.

2. Click the Port tab. The Operations panel opens with the Port

and Beacon pages displayed.

3. Click the check box (checked) in the Beaconing State column

and click Activate to remove the check mark and disable

beaconing. The message Your changes have been

successfully activated appears.

Continue to the next step.

At the View panel, does the Operational State field display a

Segmented message?

NO YES

↓ Port segmentation is indicated. Go to step 18 to obtain event

codes. If no event codes are found, go to MAP 0600: Fabric,

ISL, and Segmented Port Problem Determination on

page 3-54. Exit MAP.

At the View panel, does the Operational State field display a message

indicating a port problem?

NO YES

↓ Go to step 18 to obtain event codes. If no event codes are

found, go to MAP 0500: Port Failure and Link Incident

Analysis on page 3-35. Exit MAP.