958-000284-007, March 2005)

Thefeatureconfiguresaswitchordirectorsothatnoframedataisstoredafterapower

off. Without Full Volatility, if the switch or director experiences a fault condition, a

dump of the embedded m emory space is captured into nonvolatile memory. This dump

retains the last 30 frames transmitted from and last four frames transmitted to the

embedded por t. With Full Volatility installed, this dump does not occur when a fault

condition occurs. Although this lim its the amount of diagnostic information available

for p otential problem resolution, the vast majority of problems are typically resolved

without the dump files.

Contact your sales representative to purchase a feature key for Full Volatility.

CLI threshold alerts

With firmware 0

6.00.00 and later, the CLI allows you to set and monitor Throughput

Threshold Alerts (TTAs).

CLI show.even

tLog command

With firmware 06.00.00 and later, the CLI show.eventLog command has been

enhanced. The command now displays a Link Incident log and Event log.

MIHPTO value

With firmware 06.00.00 and later, the internal Missing Interrupt Handler Primary Time

Out (MIHPTO) value has been changed from 15 seconds to 3 minutes.

EWS enhancements

With firmware 06.00.00 and later, EWS enhancements include support for managing

the SANtegrity Binding feature and Enterprise Fabric mode, and providing the Link

Incident log and the Open Trunking log.

Preferred Path support

With firmware 07.00.00 and later, this allows users who are not using HAFM to

configure preferred data paths through the EWS interface. A preferred path is an ISL

data path between multiple fabric elements (directors and switches) that users can

configure using the source and exit ports of the origination fabric element, and the

domain I D of the destination fabric element.

HP StorageWorks Edge Switch release notes