HP StorageWorks Enterprise File Services WAN Accelerator 2.1.3 Release Notes (February 2006)

SH2 (config) # write memory

SH2 (config) # restart

3. On WAN Accelerator-3, at the system prompt, enter the following commands:

SH3 (config) # peer <WAN Accelerator-4 IP addr> version min 6

SH3 (config) # peer <WAN Accelerator-4 IP addr> version max 6

SH3 (config) # write memory

SH3 (config) # restart

4. On WAN Accelerator-4, at the system prompt, enter the following commands:

SH4 (config) # peer 0.0.0.0 version min 5

SH4 (config) # peer 0.0.0.0 version max 5

SH4 (config) # peer <WAN Accelerator-1 IP addr> version min 6

SH4 (config) # peer <WAN Accelerator-1 IP addr> version max 6

SH4 (config) # peer <WAN Accelerator-2 IP addr> version min 6

SH4 (config) # peer <WAN Accelerator-2 IP addr> version max 6

SH4 (config) # peer <WAN Accelerator-3 IP addr> version min 6

SH4 (config) # peer <WAN Accelerator-3 IP addr> version max 6

SH4 (config) # write memory

SH4 (config) # restart

NOTE: If you upgrade the remaining WAN Accelerators in your network (WAN Accelerator-5 through

WAN Accelerator-10), and there are no more version 1.2 WAN Accelerators, you can remove all the

version configurations on WAN Accelerator-1 through WAN Accelerator-4.

1. Connect to the Management Console on each WAN Accelerator.

2. Install the version 2.1 image in the Setup: Software Upgrade page.

3. Save the current configuration in the Setup: Configuration Manager page.

4. Reboot the WAN Accelerator in the Setup: Reboot WAN Accelerator page.

5. Connect to the CLI on each of the 3 WAN Accelerators you originally upgraded (that is, WAN

Accelerator-1, WAN Accelerator-2, WAN Accelerator-3, WAN Accelerator-4).

6. On WAN Accelerator-1, at the system prompt, enter the following commands:

SH1 > enable

SH1 # configure terminal

SH1 (config) # no peer 0.0.0.0

SH1 (config) # no peer <WAN Accelerator-2 IP addr>

SH1 (config) # no peer <WAN Accelerator-3 IP addr>

SH1 (config) # no peer <WAN Accelerator-4 IP addr>

SH1 (config) # write memory

SH1 (config) # restart

7. On WAN Accelerator-2, at the system prompt, enter the following commands:

SH2 > enable

SH2 # configure terminal

SH2 (config) # no peer 0.0.0.0

SH2 (config) # no peer <WAN Accelerator-1 IP addr>

SH2 (config) # no peer <WAN Accelerator-3 IP addr>

SH2 (config) # no peer <WAN Accelerator-4 IP addr>

SH2 (config) # write memory

SH2 (config) # restart

8. On WAN Accelerator-3, at the system prompt, enter the following commands: