HP StorageWorks Enterprise File Services WAN Accelerator 2.1 Command Line Interface Reference Guide (November 2005)

HP STORAGEWORKS EFS WAN ACCELERATOR COMMAND-LINE INTERFACE REFERENCE MANUAL 91
4 - CONFIGURATION-MODE
C
OMMANDS
in-path rule discard
Description Packets for connections that match the rule are dropped silently. The HP EFS WAN
Accelerator filters traffic that matches the rules in discard.
Syntax in-path rule discard {scraddr <addr> dstaddr <addr> dstport <port>} rulenum
<rulenum> [vlan <vlan tag ID>]
Parameters
Example
minna (config) # in-path rule discard scraddr 10.0.0.2 dstaddr 10.0.0.1
port 1234 rulenum 2
minna (config) #
in-path rule fixed-target
Description Adds an in-path, fixed-target rule. Specify an HP EFS WAN Accelerator between the
client and server on which to intercept and optimize traffic. The no command option
disables the in-path rule. The no command option has the following syntax: no in-
path rule <rulenum>.
Syntax in-path rule fixed-target {[scraddr <addr>] [dstaddr <addr> [dstport <port>]]} |
[target-addr <addr> [target-port <port>] | [backup-addr <addr> [backup-port
<port>]]
|
[neural-mode <mode>] | [optimization <policy>] | [vlan <vlan tag ID>] |
[rulenum <rulenum>]
Parameters
srcaddr <addr> Specifies the source IP address.
dstaddr <addr> Specifies the destination IP address.
dstport <port> Specifies the destination port for this rule. The destination port can
be a single port (number), a port label, or all specifies all ports.
srcaddr <addr> Specifies the source IP address.
rulenum <rulenum> Specifies the rule number: 1-N, start, or end. The rule inserts itself
at the rule specified. For example, if rulenum is 3 then the new rule
will be #3, the old #3 rule will be #4 and so forth. The start option
specifies the rule to be the first rule and end specifies it to be the last
rule.
vlan <vlan tag ID> Specifies the VLAN tag ID for which the rule applies. The VLAN
identification number is a value with a range from 0-4094 (0
specifies no-tagging).
srcaddr <addr> Specifies the source IP address for this rule. For example:
10.0.0.3/24
dstaddr <addr> Specifies the destination IP address for this rule. For example:
10.0.0.0/24