HP StorageWorks HSG80 ACS Solution Software V8.8 for OpenVMS Installation and Configuration Guide (AA-RV1PA-TE, March 2005)

FC Configuration Procedures
142 HSG80 ACS Solution Software V8.8 for OpenVMS Installation and Configuration Guide
■ Configuring a Single-Disk Unit (JBOD), page 145
■ Configuring a Partition, page 146
Figure 33: Storage container types
Configuring a Stripeset
1. Create the stripeset by adding its name to the controller's list of storagesets
and by specifying the disk drives it contains. Use the following syntax:
ADD STRIPESET STRIPESET-NAME DISKNNNNN DISKNNNNN.......
2. Initialize the stripeset, specifying any desired switches:
INITIALIZE STRIPESET-NAME SWITCHES
See “Specifying Initialization Switches” on page 77 for a description of the
initialization switches.
3. Verify the stripeset configuration:
SHOW STRIPESET-NAME
4. Assign the stripeset a unit number to make it accessible by the hosts. See
“Assigning Unit Numbers and Unit Qualifiers” on page 147.
Partition
Striped mirrorset
(R0+1)
Stripeset
(R0)
RAIDset
(R3/5)
Mirrorset
(R1)
Single
devices
(JBOD)
Storagesets
Containers
CXO6677A